10kW 10000W 230V AC Voltage Regulator

Ready-to-use voltage regulator module 50-230V 10000W. It was based on a triac. The set also includes a display on the cable for convenient installation in the housing, other devices, etc. The module regulates the voltage by "cutting" the sine wave of AC 230V alternating voltage. It is possible to extend the cables connecting the panel with the module using XH 3S extension cable.

Application:

Regulating the charging current in rectifiers (on the primary side of the transformer)
Speed ​​control of single-phase AC motors up to 10000W
Adjusting the light intensity (dimmer)
Temperature control in soldering irons
Smooth speed control of motors in power tools, fans, etc.
Regulating the charging current in battery chargers
Regulation of heaters, radiators, etc.
And many others…

Technical data

Model: Voltage regulator 230V AC 10000W - display
Regulation range: 0 ~ 230V AC
Type of adjustment: Display
Resolution: 1%
Dimensions (L x W x H): 58 x 85 x 38
Signal cable length: 30cm
Executive element: triac

Included

10000W 230V AC voltage regulator,
display with buttons,
mounting screws.

Important safety note

There is life-threatening high voltage on the side of the executive module on the controller board!
Under no circumstances should you test the device without proper protection, as this may result in electric shock.
There is high potential on almost every component on the module side. Be especially careful!