13.56MHz PN532 NFC Card-Reader Module Set - for Raspberry Pi, Arduino

The board allows reading and writing data from NFC and RFID devices at a frequency of 13.56 MHz. The module based on the PN532 chip has an onboard antenna and is powered by 3.3 V or 5V. It supports three communication interfaces: I2C, SPI and UART. Effective communication distance up to 3 cm.
Equipped with integrated antenna, no external antenna coil is required.

The set contains a module + RFID card + RFID fob.

Technical Data:

NFC controller: PN532
Operating voltage: 3.3V/5V
Operating frequency: 13.56MHz
Communication interfaces: I2C, SPI, UART (default)
Default baudrate: 115200 bps
Compatible with ISO14443 Type A and Type B standards.
Maximum supply current: 150mA
Operating current (standby): 100 mA.
Operating current (write mode): 120 mA.
Operating current (read mode): 120 mA.
Hands: PWR
Interface: Raspberry Pi's 20pins interface standard SPI interface.
Dimensions: 79 x 48 x 11 mm (L x W x H).
Weight: 15.9g

Additional information, software examples, etc.:

www.waveshare.com/wiki/PN532_NFC_HAT

Operating modes:

• reader/writing mode supporting ISO/IEC 14443A / MIFARE scheme
• reader/writing mode supporting FeliCa scheme
• reader/writing mode supporting ISO/IEC 14443B scheme
• card operation mode supporting ISO 14443A / MIFARE scheme
• card operation mode supporting FeliCa scheme
• ISO/IEC18092, ECM340 point-to-point