50KG Strain Gauge Beam - Scale Tension Sensor

Internal 1000 Ohm half-bridge strain gauge load cell, range is 50kg, half-bridge structure.

When measuring, the correct force is applied to the outer side of the strain E-shaped beam portion of the sensor (i.e., a strain gauge affixed to the middle, with a beam of white plastic cover arm) and the outside edges to form a shear force in the opposite direction, i.e.,in the middle of strain beam bending necessary changes can occur under stress, strain beam side by another force can not have a barrier.

The sensor use the following three methods:
- Using a single sensor with external resistors full bridge measurement range of a sensor range: 50kg. Higher requirements for external resistor
- Using 2 full-bridge sensors measuring range is the range of 2 sensors and: 50kgx2 = 100kg
- Using 4 full-bridge sensors measuring range is the range of 4 sensors and: 50kgx4 = 200kg

Technical data:

Dimensions: 34x34 mm
Range: 50kg
Zero point output: ±0.3mV/V
Output sensitivity: 1.0±0.15mV/V
Insulation resistance: ℃≥2000MΩ
Rated voltage: 5-10V DC
Leads length: 45cm