ESP8266MOD WiFi Network Module + Goldpin Header Adapter Board

The ESP8266MOD module is based on the ESP8266 chip. Works on the Wifi 802.11 b / g / n standard at 2.4 GHz. This device can be used as a converter for connecting the microcontroller to Wi-Fi or as an independent device, because it has a controller with FLASH and ROM memory. The ESP12 has 4MB of Flash memory. It is possible to program the module using LUA scripts, Arduino IDE or AT commands.

Specification:
2.4 GHz frequency
WiFi standard support: 802.11 b, g, n
Modes of operation:
AP (Access Point)
STA (standalone)
AP + STA
Security:
WPA
WPA2
AT commands

Pinout:
9 x GPIO - digital outputs / inputs
1 x ADC input - digital-to-analog converter
2 x UART (TX, RX) - for communication, e.g. with Arduino
Supply voltage: 3.3V
Power consumption at rest: Mon. 10u
Mounting: SMD / THT:
hole diameter: 0.9 mm
Pins pitch: 2 mm
It has an antenna on a PCB
Shielded module
Dimensions: 22 x 16 mm

The adapter board allows you to connect a Wi-Fi module in the version ESP-12E as well as ESP-07 and ESP-08. The adapter changes the spacing of the pins from 2 mm to the standard 2.54 mm goldpin pitch, thanks to which the system can be plugged into, for example, a breadboard. The kit includes an adapter and 2.54 mm goldpin connectors (not soldered). The board has a place for soldering the voltage stabilizer, if it is used, the SMD R2 jumper should be desoldered.

Set contains:
- ESP8266MOD module
- ESP adapter module
- Male goldpin headers