L293D 4-Channel Stepper Motor Driver Shield Arduino

Shield for Arduino with L293D drivers to control high power motors. It allows you to control four DC motors or any two stepper motors.

Specification:
The module with the L293D driver allows you to control the direction of rotation and speed of the motors and connect two RC servos.
Shield enables two-way operation:
4 DC motors with 8 bit speed resolution.
2 stepper motors (unipolar or bipolar)
Motor Shield is invaluable in the construction of robots, the movement of which is based on DC motors.
The system is easy to assemble - only plug into Arduino
It supports motors operating on voltage up to 36 V DC.
L293D incorporates overheating protection.
The maximum channel current is 600mA.
Thanks to the ARK screw connectors, the power supply and the motors themselves can be easily connected by screwing the wires with a screwdriver.
Control signals were output to the popular goldpin connectors by direct connection to Arduino boards
Pull-up resistors keep motors off when energized.
Shield allows you to connect an additional power supply, thus separating the power supply of the motors from the logic power supply.

Technical data:
- Logic working voltage: 5V
- Maximum supply voltage of motors: 36V
- Current per channel: 0.6A
- Maximum current per channel: 1.2A
- Number of channels: 2
- Number of supported stepper motors: 2
- Number of supported DC motors: 4
- Built-in RESET button
- Pull-up resistors to keep the motor off during start-up
- Terminal block connectors for easy assembly of motor cables
- Dimensions: 55 x 70mm

Compatible with:
- Arduino MEGA 2560
- Arduino UNO
- Arduino Leonardo
- Arduino Duemilanove