RAMPS 1.6 RepRap Controller - 3D Printer Driver - RepRap 3D Printer Arduino MEGA Shield
New 1.6 version
RAMPS 1.6 controller is a shield for Arduino MEGA 2560 and allows you to easily create a 3D printer or, for example, a milling machine. Ramps 1.6 is an upgraded and optimized version of RAMPS 1.5.
This system controls all the processes of the device - after connecting MEGA 2560 microcontroller, display and motor stepsticks, we have complete electronics for the printer.
Product features
A driver that allows you to connect stepper motors with additional elements necessary to run a 3D printer.
The system (as a shield) works with Arduino Mega 2560 - through direct connection.
The board requires five modules with the A4988 driver (stepsticker) to work.
In addition to the listed elements, Ramps 1.6 allows you to connect:
- end sensors ENDStop
- plastic injection control equipment
- LCD display
- SD memory card reader
- Bluetooth module
- other
A detailed description, diagrams and connection instructions can be found on Wiki-Ramps,
Technical data
Current consumption: minimum 5 A (depending on the configuration, details on the Ramps wiki).
The shield is compatible with Arduino Mega 2560 and it can have limit sensors connected.
AUX connector for connecting additional elements, e.g. a Bluetooth module (details on the Ramp wiki)
Dimensions: 101.5 x 60.5 mm
Support motor drivers: support A4988 DRV8825 and other motor drivers(support five motor drivers Simultaneously)
Input voltage: 12V
Power: 200W
MOSFET used: B55NF06c
Maximum load current :10A
Ramps 1.6 is a 4-layer board.