Wattmeter - Power Meter - Voltage Current Meter PV
AC CURRENT AND VOLTAGE METER WITH A WATTMETER
e.g. for measuring the operating parameters of photovoltaic panels
New larger version with a clearer 4-in-1 display also with backlight. For use in cars, boats, motorcycles and for voltage and current testing devices. Widely used in electromechanical devices. It allows you to monitor the battery and the electrical system, solar energy, wind energy, HHO installation.
Specification:
Measurement and monitoring of electrical parameters (voltage, current, kWh, watts)
Overload alarm function (exceeding the power alarm threshold, the backlight flashes)
Programming of the alarm threshold function (you can set your own power alarm threshold)
Power (kWh) Function with reset button
Data storage after power off
Screen function - large LCD screen Full smooth display (voltage, current, kWh, power)
Backlight function
Technical data:
Working voltage: 80 - 260VAC
Test voltage: 80 - 260VAC
Rated power: 100A / 22000W
Working frequency: 45-65Hz
Display type: - LCD display with backlight
Measurement precision: Class 1 (± 1%)
Display:
The display interface is a large LCD screen which displays voltage, current, power and energy parameters at the same time.
Power: measuring range 0 ~ 22kW
less than 1kW Displayed format: 0.0 ~ 999.9W
From 1 - 10kW displayed format: 1000 ~ 9999W
10kW and more displayed format: 0.1 ~ 22.0kW
KWh: measurement range 0 ~ 9999kWh
less than 10kWh Displayed format: 0 ~ 9999Wh
10KWh and more Displayed format: 10 ~ 9999kWh
Voltage range: 80-260V
displayed format: 80 ~ 260V
Current range: 0 ~ 100A
Displayed format: 0.00 ~ 99.99A
Button functions:
backlight control - you can turn on / off the backlight by pressing briefly
Power reset
Step 1: long press the button (about 5 seconds) until the display flashes, then release the button;
Step 2: For a short moment, press the button again, then reset to zero (kWh) after flickering;
Step 3: When long press the button for 5 seconds until there is no more flickering, power (kWh) data is not cleared.
Alarm setting (power)
Step 1: Keep holding the button until "SET CLr" is displayed on the LCD screen, then release the button.
Step 2: Power window displays the current value set for alarm and the last digit starts flashing, then you can short press to add 1, when there is no operation for 3 seconds, the digit position will be set automatically
Step 3: Long press the button (time about 5 seconds) will save the value automatically and exit, rated power range 0.0 ~ 22.0kW
Note: Please make sure to connect the wires correctly (polarity)
This module is not suitable for outdoor use.
The connected load cannot exceed the permissible supply voltage and rated current supported by the meter.
APPLICATION:
The panel meter can be used to measure the operating parameters of panels or other electrical devices.
The readable display allows for the analysis of e.g. the battery charging process or the power consumption by AC receivers. Also for measuring parameter differences between photovoltaic panels.