WeMos D1 Mini ESP8266-12F Module Arduino IoT

The development board allows you to integrate the Wi-Fi module (ESP8266), known for its ease of use and considerable possibilities, in projects requiring access to the network, e.g. as part of IoT. The module has 11 digital I / O pins with interrupts, PWM, I2C and 1-Wire. There is also 1 analog input (3.2V max input). The module is programmed via the Micro USB connector. The board is compatible with Arduino, MicroPython, NodeMCU.

WeMos D1 MINI module is based on the ESP12 chip and has 11 GPIO pins. Works on the Wifi 802.11 b / g / n standard at 2.4 GHz. This device can be used as a converter for connecting the microcontroller to Wi-Fi or as a separate and independent controller (standalone device). The ESP12 has 4MB of Flash memory. It is possible to program the module using LUA scripts, Arduino IDE and also using AT commands. The board has a soldered CH340 programmer (the driver must be downloaded), as well as a Micro USB connector, so we do not need any additional elements to program the module. The set includes 3 types of goldpin header connectors for soldering: 2x goldpin connector, 2x goldpin short socket, 2x goldpin extension socket.


Specification:

Frequency: 2.4 GHz
WiFi standard support: 802.11 b, g, n
Modes of operation:
AP (Access Point)
STA (standalone)
AP + STA
Security:
WPA
WPA2
AT commands

Pinout:
9 x GPIO - digital outputs / inputs
1 x ADC input - digital-to-analog converter
1 x UART (TX, RX) - for communication, e.g. with Arduino
Supply voltage: 5V - built-in voltage stabilizer
Power consumption at standby: less than 10 uA
Mounting: SMD / THT:
hole diameter: 0.9 mm
Pins pitch: 2 mm
It has an antenna on a PCB
Shielded module
Built-in RESET button
Dimensions: 26 x 34 mm

Attention!
The maximum allowed voltage on the lines of the ESP8266 system is 3.3 V. Make sure that the add-on module attached to the board does not force the lines of the ESP8266 system to a higher voltage than allowed.


Set contains:
Board compatible with WEMOS D1 mini
3 types of goldpin connectors for soldering: 2x goldpin strip connector, 2x goldpin short socket, 2x goldpin extension socket

Useful links:
Home page of the WEMOS D1 project http://www.wemos.cc/Products/d1_r2.html
Drivers https://www.driverscape.com/download/usb-serial-ch341