1-Channel 5V 30A/250V AC Relay Module for DIN Rail - Optoisolation

The module adopts high-quality genuine 30A relay, the maximum load of a normally open interface: AC 250V / 30A, DC 30V / 30A;
It uses chip optocoupler isolation, strong driving ability, stable performance.

Trigger current of 5mA.
The operating voltage of the module is 5V DC
The module can be jumper activated to set a high or low level trigger.
All interfaces can be directly connected through the terminal block, which is very convenient.

Module size: (length * width * height)
Without rail: 72mm * 40mm * 24mm
With rail: 86mm*43mm*45mm
Product net weight: about 46g
There are 4 fixing bolt holes, the hole is 3.1mm, the spacing is 44.5mm * 27.5mm

Interface description:
1. DC +: module DC power supply positive (trigger terminal voltage positive)
2. DC-: module DC power supply negative (trigger terminal negative voltage)
3. IN: signal trigger end (the default trigger voltage is the same as the power supply)
4. High / Low edge trigger mode selection, when the jumper is connected with the L terminal, the terminal is low edge trigger, and when connected to the H terminal it turns high level
5. Normally closed end (NC): Relay normally closed.
6. Common (COM): common relay
7. Normally open (NO): The relay is normally open.